*For Thin or Weak necked cutters use lower IPT to start.
*Smaller diameter cutter use lower IPT to start.
RPM = (SFM x 3.82) ÷ Diameter
SFM = RPM x .262 x Diameter
Chip Load/Tooth(IPT) = in/Min ÷ # of Teeth ÷ RPM
Feed rate(IPM) = Chip Load/Tooth x # of Teeth x RPM
Cubic Inches/Min = R-Woc x A-Doc x in/Min
IF ANY PRODUCT IS NOT SATISFACTORY WE WILL MODIFY, REPLACE, OR REFUND.
AB TOOLS, Inc.
Manufacturing High Performance Rotary Cutting Tools since 1977
1051 Aviation Blvd. | Lincoln, CA 95648
Phone: (916) 408-2442
Fax: (916) 993-3949